VEVOR Discharge Hose 2" x 50 ft PVC Lay Flat Backwash Water Pump Pool Hose, for Swimming Pool Sand Filter & Sump Pump, Water Transfer Drainage, Weather & Burst-Resistant, with Pin Lug Fittings, Blue

Discharge Hose 2" x 50 ft PVC Lay Flat Backwash Water Pump Pool Hose: choosing this model

A flat PVC discharge hose carries pumped water away from a pool filter or dewatering pump. It packs down when empty, unlike rigid pipe or a permanently pressurised hose.

Features of this version

• Discharge Hose 2" x 50 ft PVC Lay Flat Backwash Water Pump Pool Hose
• for Swimming Pool Sand Filter & Sump Pump
• Water Transfer Drainage
• Weather & Burst-Resistant
• with Pin Lug Fittings
• Blue

Practical applications

The 2-inch by 50 ft format can help route backwash or drainage to an approved outlet. It is intended for discharge rather than suction duties.

What matters when comparing models

Flow and pressure figures normally describe different operating points. Work from the required delivery head, pipe length, resistance and duty cycle instead of choosing by the largest advertised number.

Check before ordering

Check outlet diameter, coupling or clamp needs, pump pressure and drainage permissions. An empty lay-flat hose may kink if forced around sharp bends or under traffic.

Use and upkeep

Unroll fully before pumping and secure the free end to prevent whipping. Drain, clean and dry before folding away to limit mildew and cracking.